16 Inch Tempered Glass Screen Protector for HP Envy 16/ Spectre x360 16/ ZBook 16/ OmniBook 7 16/ OMEN 16/OmniBook 7 Flip 16/ EliteBook 860 865 (G11 G10 G9)/Pavilion 16/ProBook 16,HP 16" 16:10 Laptop

I purchased this protector for my HP Envy 2 in 1, 16" 2k touchscreen - AMD Ryzen. I was a little disappointed when I went to size and assemble it because I thought it was supposed to fit the entire screen. (Attached photo for reference) After searching around and asking the place where I originally purchased my computer, I was told this is how the protectors are made for this specific model. Therefore, I went ahead and put it on. It came with step by step directions and I had no issues whatsoever. It went on perfectly with no bubbles. There is no glare. I've had it on for a few months now and I clean with an alcohol wipe weekly. It is holding up just fine and the edges haven't started lifting either.

Item for perfectly with barely any space by the bezel

Works well with my HP Envy x360 laptop

Perfect

Product was installed no ease, it covers just the screen itself( does not cover entire screen surface, "screen to edge") but I am still confident in it's quality and protection!

I thought this was anti-glare but no, that was my bad. But this collects all the fingerprints, even with my pen. Also fits poorly on the screen.

I have not used anything like this on a laptop before. I have used privacy screens that cling to the laptop frame with plastic corners, magnets, and similar attachments. Now if we're talking Smartphones or tablets I have done this plenty of times. I used the same install process for this protector as for those type of devices. If you wonder why no pictures with the laptop screen on, I could not see the protector with laptop on. I could get close or zoom in but then the images showed more of the frequency interference lines you are familiar with and that did not represent the protector.1) Run a hot shower in a smaller bathroom. 2) Position the protector using the guide stickers. 3) Once there is enough steam in the air to start fogging my glasses. 4) Wipe the display with the alcohol wipes. 5) Use dry wipe and if in doubt use the sticker to grab any hairs or crumbs or similar. 6) Finally, carefully remove the backside cover sheet as I let the protector contact the display and let it adhere. 7) Using the reenforced card to smooth out the protector and remove air gaps and bubbles. 8) Move card to left and right edges as protector covers more of the screen till the bottom edge. 9) As long as nothing has gotten between the protector and display you are done. 10) If not so lucky, you will need to lift the edge closest to the item under the protector and get the sticker under the protector. 11) Either the sticker needs to be facing the screen or the protector depending where the item is need to be removed.Check the results in the pictures.

After perfectly cleaning all lint, etc, fun screen, it STILL left large bubbles under the protector.