Affordura PWC Fender Bumper with Elastic Cords 2x 18.5 inch for Yamaha Jet Ski Dock Bumpers - 14 x 6 x 3.2 inch

As others have reviewed, they are a pain to set/configure if you have to reach into your bow to retrieve them, find the bungie cords and set them up all while floating next to a dock (especially if its wavy). But once these things are in place and secure, they are super effective and absolutely necessary when docking if you don't want to ding up your PWC when docking. I also have the Yamaha OEM bumpers, which I like, but they don't protect your PWC as well as these do. I use both together, especially if I'm docked in rougher waters.But I always prefer staying away from docks with a PWC. I'd way rather beach it or use SandSharks and tether it in the water away from docks that can destroy your PWC in a matter of minutes if not protected.

I don't have a good anchor point for a fender within range of the bungee cord near the front. My first attempt ended up with the fender and bungee cord falling into the water. Of course, the bungee cord separated and sank to the bottom. I found a better location that I could reach with a longer bungee cord. I discovered that I could tether the original bungee cord to the rear fender with a zip tie through the grommet and the loop in the bungee handle. The new bungee cord didn't have such a loop. So, I used a wire tie and wound it around the cord, just above the plastic hook. The zip tie and wire tie only act as tethers and do not support the fenders. The fender covers have withstood abrasion. So far, so good.

Works but should have a couple extra sized bungees included with it. The ones that came with i can only make work with the passenger hand holds. Will need to buy a longer one.

Products were as described and shipping time was fast.

The product is durable and saves from scratch launching or tying the ski with the boat. Only problem is the bumpers keep on falling off the hooks or boat sides. Even little bit of waves will make it fall off. best is to ziptie the hooks with the bumpers to avoid if from falling off the hooks. i would rate this 3.5 for this.

These are great used them for a sho cruiser and jetblaster just buy a bungee with clips at the ends because first day I pulled it out on the water and the bungee fell in and sank immediately but product does the job I recommend

Fit in mi seadoo

Works great on '23 Kawasaki Ultra LX, bottom locks into the rail where top meets the hull so it stays put. Loses a star because the bungee cord is not affixed to the bumper so it can easily get lost. I ran a plastic tie thru the bungee eye to secure it to the bumper.